HYDRANT FLUSHING

 

During the period of May 12, 2025, through May 16, 2025, SMCMUA will be performing routine hydrant maintenance and flushing on the below streets and surrounding areas between the hours of 9:00 AM and 4:00 PM. 

 

Altamont Ct
Catherine Lane
Colles Ave
Crestwood Rd
Dehart St
Dogwood Rd
Doughty St
Dumont Place
Elm St
Erskine Dr
Farragut Place
Ford Ave
Franklin Place
Franklin St
Green Hill Rd
Green St
Hamilton Rd
Headley Rd
Hill St
King St
Knollwood Rd
Lidgerwood Parkway
MacCulloch Ave
Madison St
Maple Ave
Maxwell Ct
Miller Rd
Oak St
Ogden Place
Overlook Rd
Paula Ct
Pine St & King Place
Revere Rd
Vanderpool Dr
Wetmore Ave
Wilmot St

 

 

What to Expect:

While hydrant flushing typically will not interrupt your water service, you may notice a temporary drop in water pressure while crews are working in your area. There is also the possibility that water may become temporarily discolored. This is normal. The discolored water does not pose a health hazard; however, iron (red water) and manganese (black water) may be stirred up within the system during the flushing procedures. If this happens, simply let your water run until it runs clear.
 

Customer Tips:

  • Avoid running your tap water and using the washing machine or dishwasher while crews are flushing your area. This will reduce the chance of pulling discolored water into your home.

  • If discolored water occurs, simply run the cold water for a few minutes until it clears. This will allow the sediment to work its way out of your pipe.

  • Check for discolored water before using the washing machine or dishwasher. Wait until the water runs clear before doing laundry or running the dishwasher. NOTE: If your laundry does become stained, do not put your laundry into the dryer. Re-wash laundry immediately and add a rust remover.

  • In some cases, slight discoloration might linger for a few hours. This discoloration affects the appearance of the water and does not affect water quality. No health hazards are associated with discolored water from hydrant flushing.

  • If water pressure or water volume seems low after flushing has been completed, check your faucet screens (aerators) for trapped particles.
     

SMCMUA apologizes for the inconvenience.  Thank you for your patience.

 

To receive similar water related alerts, please UPDATE YOUR ACCOUNT INFORMATION and register for Smart911.

 

(Updated:  May 12, 2025, at 8:30 AM)

 

Return to Home